News

In the PCB layout process, after completing the system planning, the PCB diagram should be checked to see whether the system planning is reasonable and whether the best results c...

I. Enhance the ability of PCB to resist deformation The deformation of the circuit board is usually comes from rapid thermal expansion and contraction caused by high-tempe...

For electronic equipment, a certain amount of heat is generated during operation, which causes the internal temperature of the equipment to rise rapidly. If the heat is not ...

Most people cannot tell the difference between a double-sided circuit board and a multilayer circuit board with the naked eye. If you do not carefully distinguish the appear...

Nowadays, electronic products are developing towards miniaturization, funtionalization, high performance and high reliability. The high-frequency board is high-frequency circuit ...

First: The Purpose of Blackening and Browning   1. Remove pollutants such as oil and impurities on the surface; 2. Increase the specific surface area of t...

1. First, there must be a reasonable direction. Such as input/output, AC/DC, strong/weak signal, high frequency/low frequency, high voltage/low voltage, etc... Their...

PCB prototype refers to the trial production of printed circuit boards before mass production. It is mainly for PCB engineers to design circuits and complete PCB layout, and then...

In the screen printing process of the circuit board, it can be divided into 9 parts and 56 variables, which requires correct operating procedures or the following phenomenon will...

The development of electronic products inevitably goes through the trial production process of the circuit board (PCB). The most commonly used method is to put the designed PCB f...